Water Washout Characteristics Of Lubricating Greases

ASTM D1264 IP 215
Water Washout Characteristics of Lubricating Greases
This test method covers the evaluation of the resistance of a lubricating grease to washout by water from a bearing, when tested at 38 and 79°C (100 and 175°F) under the prescribed laboratory conditions. It is not to be considered the equivalent of service evaluation tests. This test method may not be suitable for some greases containing highly volatile components.

Features
• Thermostatic cabinet controlled by a touch panel
- digital timer
- bath temperature
- motor speed rotation RPM
• 2 × 175 W stainless steel heaters
• Two bearing type 6204
• PT100 bath sensor
• Low-voltage electric motor with direct coupling of the 600 rpm shaft
• Bearings block assembly
• Low-voltage water pump for the delivery to the jet tip of 300 ml/min ± 10% and an electric open/closing valve
• Bypass tube and recovery system with external drain tap
• Manual flow regulator valve
• Cooling fan

Power Supply
• 220 or 115 Vac 50/60 Hz